Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
- Engine
   Check of kompressionny pressure in cylinders
   Engine check by means of the vacuum gage
   Replacement of a belt of a drive of auxiliary units and elements of the mechanism of its tension
   + Petrol models
   - Diesel models
      Removal and engine installation
      Removal and installation of covers of a drive of GRM
      Replacement of a gas-distributing chain
      Removal and installation of components of a drive of GRM
      Installation of base provision of camshafts
      Verification of the base provision of a balancing shaft (only series 628 engines)
      Removal and installation of GRM components
      Removal and head installation (ok) cylinders
      Removal and installation of the electromotor of shutdown of inlet port (series 612 engine)
      Removal and installation of a final collector
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of a back face cover, replacement of a back epiploon of a cranked shaft
      Removal and installation of a damper krutilny fluctuations/pulley of a driving belt
      Removal and flywheel installation / driving disk
      Removal and installation of support of a suspension bracket of the power unit
      Service of system of greasing
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a final collector

М612

Details of installation of a final collector of the engine of a series 612


 PERFORMANCE ORDER

  1. Details of installation of a final collector of the engine of a series 612 are shown on an illustration which all references meeting in the text concern.
  2. Remove the primary catalytic converter (120/1).
  3. Remove a turbokompressor (110).
  4. On models from AT remove a basic arm of a directing tube щупа measurements of level of AT, - a tube do not remove.
  5. Give самоконтрящиеся nuts (4) and remove a final collector (1).

Самоконтрящиеся nuts of fastening of a final collector are subject to replacement without fail!

  1. Check a condition of fixing hairpins, in case of need make replacement.
  2. Carefully smooth out interfaced surfaces of a collector and the block of cylinders.
  3. Installation is made upside-down, - do not forget to replace sealing laying (2).

М628

Details of installation of final collectors of the engine of a series 628


 PERFORMANCE ORDER

  1. Details of installation of final collectors of the engine of a series 628 are shown on an illustration which all references meeting in the text concern.
  2. Remove the corresponding turbokompressor.
  3. Give nuts (5) and remove a final collector (1/3).

Самоконтрящиеся nuts of fastening of a final collector are subject to replacement without fail!

  1. Check a condition of fixing hairpins (4), in case of need make replacement.
  2. Carefully smooth out interfaced surfaces of a collector and the block of cylinders.
  3. Installation is made upside-down, - do not forget to replace sealing laying (2).