Removal and flywheel installation / driving disk М111
Details of installation of a flywheel / a driving disk on the series 111 engine
|
|
- Details of installation of a flywheel / a driving disk on the engine of a series 111 are shown on an illustration which all references meeting in the text concern.
- Remove transmission (see. Head Manual box of gear shifting and Avtomatichekhkaya transmission).
- On models from RKPP remove coupling (see. Head Transmission line).
- Establish a blokirator (3).
- Turn out fixing bolts (1).
- Remove a flywheel (86) (one-section, or two-section) / a driving disk (98).
- On models from AT remove a back washer (3).
- Installation is made upside-down.
|
|
Fixing bolts are subject to replacement without fail. |
|
|
M112/113
Details of installation of a driving disk on engines of series 112 and 113
|
|
- Details of installation of a driving disk on engines of series 112 and 113 are shown on an illustration which all references meeting in the text concern.
- Remove transmission (see. Head Avtomatichekhkaya transmission).
- Establish a blokirator (6).
- Turn out bolts of fastening of a driving disk (1) to an end face of a pin of a cranked shaft (5).
- Remove a washer (2).
- Remove a driving disk (1).
- Installation is made upside-down, - unambiguity of landing of a disk is guaranteed by existence of a cylindrical pin (4).
|
|
Fixing bolts are subject to replacement without fail. |
|
|
|