Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of the transient valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of a course of a diaphragm of BAS
   Removal and ETS/ESP hydromodulator installation
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and support installation
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of a drive of the parking brake
   Adjustment of a drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Assessment of degree of wear and replacement of brake shoes

On both axes all models considered in the real Management disk brake mechanisms with supports of the fixed type are used. The illustrative material on replacement of brake shoes is presented on illustrations which all references meeting in the text concern.

Replacement of blocks of disk brake mechanisms of forward wheels

Replacement of blocks of disk brake mechanisms of back wheels

Assessment of degree of wear

 PERFORMANCE ORDER

  1. Through observation ports in supports of brake mechanisms estimate degree of wear of brake shoes, - car operation with the blocks worn out below an admissible limit is fraught with injury of an edge between a sealing flute and a boot of the piston of the wheel cylinder.
  2. Make sure of lack of signs of development of leakages of liquid, in case of need make system check on leaks (see. The section Check of brake system on leaks).
  3. Check on existence of traces of leaks supports (31a/31b), in case of need make their replacement (see. Section Removal and support installation).

Replacement

 PERFORMANCE ORDER

  1. At the corresponding complete set disunite the socket of the contact sensor of wear of blocks (1) and remove the last, - defective sensors are subject to replacement.
  2. By means of a suitable drift (035) beat out fixing fingers (41).
  3. Remove the spring holder (41b).
  4. Having in case of need hooked the lever rested against the case of a support through a wooden pro-rate, take blocks (43) of supports (31a/31b).
  5. By means of a special clamp (031) wring out the piston of the wheel cylinder, in case of need previously having pumped out a little brake liquid from the GTTs tank.
  6. Smooth out directing blocks, - do not apply to cleaning of directing tools with sharp cutting edges.
  7. Installation is made upside-down, - it is necessary to grease the blocks equipped with laying (43b) before installation with Cu-7439 greasing.
  8. In summary check level of brake liquid, in case of need make the corresponding adjustment.