Removal and installation of a pedal of raising of the parking brake
Details of installation of a pedal of raising of the parking brake
|
|
|
|
In total самоконтрящиеся bolts and nuts are subject to replacement without fail! |
- Details of installation of a pedal of raising of the parking brake are shown on an illustration which all references meeting in the text concern.
- Make a preliminary tightness of a regulator of a weak point (the compensatory lever) driving cable.
- Uncover (71) pedal assembly.
- Remove the sensor switch of raising of the parking brake (S12).
- Disconnect a cable (85) from a tension earring on a pedal (75) and liberate it from a clamp by means of the special adaptation (043), - try not to drop a rubber ring (85с).
- Weaken a bolt (72) and remove pedal assembly (75).
|
|
Do not release bolts with TORX heads from the back party of assembly! |
- Remove an arm (77а) and disconnect a cable of an otpuskaniye of the parking brake (79) from the operating lever (77), further disconnect a cable from pedal assembly (75) by means of the adaptation (010) and remove it.
- Installation is made upside-down. In summary unload a weak point regulator (the compensatory lever) and make adjustment of a drive of the parking brake (see. Section Adjustment of a drive of the parking brake).
|
|
|