Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of the transient valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of a course of a diaphragm of BAS
   Removal and ETS/ESP hydromodulator installation
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and support installation
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of a drive of the parking brake
   Adjustment of a drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of hummock assembly of a drive of the parking brake

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

Forward cable

Details of installation of a pedal of raising of the parking brake


 PERFORMANCE ORDER

  1. Details of installation of forward section of hummock assembly of a drive of the parking brake are shown on an illustration which all references meeting in the text concern.
  2. Make a preliminary tightness of a regulator of a weak point (the compensatory lever) driving cable.
  3. Disconnect a cable (85) from the intermediate lever (91) and by means of the adaptation (043) liberate it from a clamp on the floor panel.
  4. Uncover, established at the left under the dashboard.
  5. Remove the carpet panel.
  6. By means of the adaptation (043) disconnect a cable (85) from a pedal of the parking brake (75), - try not to drop a rubber ring (85с).
  7. Having given a nut, weaken a cable cover in a foot well.
  8. Remove a clamp (85а) and push a cable through the plug through passage (85b) in the transmission tunnel.
  9. Installation is made upside-down. In summary unload a weak point regulator (the compensatory lever) and make adjustment of a drive of the parking brake (see. Section Adjustment of a drive of the parking brake).

Back cable

Details of installation of back section of hummock assembly of a drive of the parking brake


 PERFORMANCE ORDER

  1. Details of installation of back section of hummock assembly of a drive of the parking brake are shown on an illustration which all references meeting in the text concern.
  2. Remove boots of the parking brake (see. Section Replacement of boots of the parking brake).
  3. Disconnect a cable (86) from the compensatory lever (92).
  4. By means of the adaptation (043) liberate a cable (86) of clamps on floor panels.
  5. Liberate a cable (86) of stupichny assembly.
  6. Installation is made upside-down.