- Details of installation of boots of the parking brake are shown on an illustration which all references meeting in the text concern.
- Remove brake disks of back wheels (see. Section Removal and installation of a brake disk).
- By means of the special adaptation (041) disconnect coupling springs (111).
- Remove anchor springs (107) and fingers (106).
- Remove brake boots (103) from a flange of a back power shaft (68).
|
|
If boots (103) burned, it is necessary to make their replacement in a set with coupling springs (111 and 112) and anchor elements (106 and 107). |
- Disconnect a coupling spring (112) and remove a razzhimny level (109).
- Installation is made upside-down, - (109) before installation it is necessary to grease persistent and sliding surfaces of a razzhimny level with konsistentny molibdensoderzhashchy greasing, with the same greasing grease a carving of a persistent element (104), and also a cylindrical part of an adjusting castor (c). At installation actually boots release the adjusting mechanism and track, that a regulator castor (c) it appeared is developed down, track correctness of connection coupling (111 and 112) and anchor (107) springs.
- Make adjustment of the parking brake (see. The section Adjustment of a drive of the parking brake) also unload an automatic regulator.
|
|