Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
   + Coupling
   + Driveshafts
   + Power shafts
   - Transfer case and differentials
      Removal and installation of the module of management of a transfer case
      Removal and installation of a transfer case
      Replacement of an epiploon of an entrance shaft of a transfer case
      Replacement of an epiploon of a target flange of the back driveshaft
      Replacement of an epiploon of a forward target shaft
      Removal and installation of the servomotor of switching of modes of a transfer case
      Removal and installation of a chain drive of a transfer case
      Removal and installation of a forward target shaft of a transfer case
      Removal and installation of assembly of a planetary reducer of interaxal differential of a transfer case
      Removal and installation of assembly of bearing assembly of a transfer case
      Removal and installation of the oil pump of a transfer case
      Removal and installation of the mechanism of switching of a transfer case
      Removal and installation of a reduktsionny gear wheel of a transfer case
      Replacement of lateral epiploons of differentials
      Replacement of epiploons of leading gear wheels of differentials
      Removal and installation of differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of the mechanism of switching of a transfer case

Details of installation of the mechanism of switching of a transfer case

4 — the Sliding gear wheel


 PERFORMANCE ORDER

  1. Details of installation of the mechanism of switching of a transfer case are shown on an illustration which all references meeting in the text concern.
  2. Remove the oil pump of a transfer case (see. Section Removal and installation of the oil pump of a transfer case).
  3. Having pulled up, take an intermediate shaft (2).
  4. Having pulled up, remove a fork of switching (3).
  5. Carefully wash out all components, wipe suede and dry the compressed air.
  6. Installation is made upside-down.
  7. In summary check a transfer case on existence of signs of development of leaks.