Repair and service Mercedes Benz M - the Class W163 - Removal and installation of the oil pump of a transfer case//since 1997 of release / mehanicm.ru

Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
   + Coupling
   + Driveshafts
   + Power shafts
   - Transfer case and differentials
      Removal and installation of the module of management of a transfer case
      Removal and installation of a transfer case
      Replacement of an epiploon of an entrance shaft of a transfer case
      Replacement of an epiploon of a target flange of the back driveshaft
      Replacement of an epiploon of a forward target shaft
      Removal and installation of the servomotor of switching of modes of a transfer case
      Removal and installation of a chain drive of a transfer case
      Removal and installation of a forward target shaft of a transfer case
      Removal and installation of assembly of a planetary reducer of interaxal differential of a transfer case
      Removal and installation of assembly of bearing assembly of a transfer case
      Removal and installation of the oil pump of a transfer case
      Removal and installation of the mechanism of switching of a transfer case
      Removal and installation of a reduktsionny gear wheel of a transfer case
      Replacement of lateral epiploons of differentials
      Replacement of epiploons of leading gear wheels of differentials
      Removal and installation of differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of the oil pump of a transfer case

Details of installation of the oil pump of a transfer case


 PERFORMANCE ORDER

  1. Details of installation of the oil pump of a transfer case are shown on an illustration which all references meeting in the text concern.
  2. Remove bearing assembly (see. Section Removal and installation of assembly of bearing assembly of a transfer case).
  3. Remove a persistent washer (1).
  4. Remove a magnet (2).
  5. Take from a landing niche the filter (3).
  6. Turn out fixing bolts and take from a case of a transfer case pump assembly (4).
  7. Carefully wash out all components, wipe suede and dry the compressed air.
  8. Installation is made upside-down, - track, that the ledge of a bearing plate developed by heads of bolts up pump assembly was combined with lysky in bulk, - in case of need several times turn the last, - pump assembly should sit down on a power shaft completely.
  9. In summary check a transfer case on existence of signs of development of leaks.