Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of reechny transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of a mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment



Removal installation of entrance knot of the steering mechanism

Details of installation of an entrance hub (25) of the steering mechanism (23)


 PERFORMANCE ORDER

  1. Details of installation of entrance knot of the steering mechanism are shown on сопр. illustrations which all references meeting in the text concern.
  2. Bring forward wheels into rectilinear situation and fix a steering wheel by means of the special adaptation.
  3. At the corresponding complete set remove the right thermofilter (105d) systems of production of the fulfilled gases.
  4. Give a nut (25е) and a bolt of fastening of an entrance hub (25) of the steering mechanism.
  5. Release a nut (25d) boltovy connection of an entrance shaft of a hub (25) with the bottom shaft of a steering column (80а).
  6. Having accurately pulled up, liberate entrance knot (25) of assembly of the operating valve of the steering mechanism, - at all do not apply force, - in case of need slightly unclench the lock a screw-driver!
  7. At the corresponding complete set remove a casing (25f) entrance knot.
  8. Installation is made upside-down, - at installation of entrance knot the lath should be in neutral (central) situation.