Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
   + Coupling
   + Driveshafts
   - Power shafts
      Removal and installation of a rotary fist, replacement of a spherical support
      Removal and installation of a flange of a forward power shaft and dvukhryadny radial and persistent ball bearing of a forward nave
      Removal and installation of back stupichny assembly, replacement of a spherical support
      Removal and installation of a flange of a back power shaft and dvukhryadny radial and persistent ball bearing of a back nave
      Removal and installation of power shafts
      Replacement of boots of sharnirny assemblies of power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Hyundai i40 Wagon - про автомобиль Hyundai i40 Wagon

Replacement of boots of sharnirny assemblies of power shafts

Details of installation of boots of sharnirny assemblies of a power shaft (any)

37 — the Power shaft
37b — the External hinge
37с — the Internal hinge
37k — the Fixing collar
37l — the Protective cover of the internal hinge
37m — the Protective cover of the external hinge
37n — the Fixing collar

37о — the Lock ring
37р — the Lock ring
37q — the Fixing collar
37r — the Fixing collar
And — the Collar with a uvula
In — the Collar with a flute


 PERFORMANCE ORDER

  1. Details of installation of boots of sharnirny assemblies of a power shaft (forward and back) are shown on an illustration which all references meeting in the text concern.
  2. Remove the corresponding power shaft (see. Section Removal and installation of a pedal of raising of the parking brake).
  3. Release fixing collars and remove a protective cover from the corresponding hinge.

In need of replacement of an internal boot it is necessary to remove the external hinge previously.

  1. By means of suitable a drift/stripper dismantle from a shaft the external CV JOINT, then remove external/external and internal boots.
  2. Installation is made upside-down, - in order to avoid damage of boots when landing to a shaft wind a shlitsevy pin of the last with an insulating tape. Without fail replace lock rings (37о and 37q).