Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
+ Coupling
+ Driveshafts
- Power shafts
Removal and installation of a rotary fist, replacement of a spherical support
Removal and installation of a flange of a forward power shaft and dvukhryadny radial and persistent ball bearing of a forward nave
Removal and installation of back stupichny assembly, replacement of a spherical support
Removal and installation of a flange of a back power shaft and dvukhryadny radial and persistent ball bearing of a back nave
Removal and installation of power shafts
Replacement of boots of sharnirny assemblies of power shafts
+ Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a rotary fist, replacement of a spherical support Fist removal/installation
Details of installation of a rotary fist
|
|
- Details of installation of a rotary fist are shown on an illustration which all references meeting in the text concern.
- Remove the corresponding forward wheel.
- Give a stupichny nut (65а), - the nut is subject to replacement without fail.
- Disconnect electroconducting from the wheel sensor and the indicator of wear of brake shoes.
- Remove a brake disk (see. Head Brake and auxiliary systems).
- Remove from assembly of a rotary fist the wheel sensor assembled with the basic arm.
- Disconnect from a rotary fist steering draft (10), estimate a condition of a boot and degree of wear of a tip, in case of need make replacement.
- By means of a stripper liberate a spherical support from the top managing director of the lever (6) (see. Head Suspension bracket and steering). Check a boot condition, estimate degree of wear of spherical assembly, in case of need make replacement.
- By means of an ex-tractor выпрессуйте from the flange a forward power shaft.
- Having fixed a rotary fist, выпрессуйте a spherical support from the bottom rotary fist. Check a boot condition, estimate degree of wear of spherical assembly, in case of need make replacement.
- Take assembly of a rotary fist (5) from under the car.
- Installation is made upside-down, - in case of need apply the corresponding special tool. Track correctness of laying and electroconducting connection.
|
|
Replacement of a spherical support
Details of installation of the bottom spherical support in a rotary fist
|
|
- Remove a rotary fist (see above).
- Disconnect and develop a brake board.
- Vypressuyte a spherical support (7) from a rotary fist (5).
- By means of a koronchaty nut and a suitable key press a new spherical support against the stop in a rotary fist, - a nut replace.
- Plant to the place of a brake board and establish a rotary fist on the car (see above).
|
|
|
|