Mercedes M-Class W163

since 1997 of release

Repair and car operation

Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
- Power supply system and production of the fulfilled gases
   - Power supply system of petrol engines
      Check and adjustment of quantity of turns of the single course/the moment of ignition/concentration WITH
      Sbrasyvaniye of pressure in fuel system of the petrol engine
      Principle of functioning of a control system and injection of the petrol engine
      General check of system of injection of the petrol engine
      Check of injectors
      Removal and installation of components of an inlet air path
      Service of elements of a drive of a butterfly valve
      Oporozhneniye of a fuel tank
      Removal and installation of assembly of the fuel pump with the sensor of a stock of fuel
      Removal and installation of the locking fuel valve (only American models)
      Removal and installation of the fuel distributive highway and injectors
      Removal and installation топливопровода, going from the fuel filter to the fuel highway, - models 163.154.157/172/174/175
      Removal and installation of a fuel tank
   + Power supply system of diesel engines
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Sbrasyvaniye of pressure in fuel system of the petrol engine

Location of the service valve (1/1) dumpings of pressure on the fuel highway of the engine of a series 111

1/1 — the Service valve
16/8 — Sealing rings
17 — the Fuel highway

17/2 — the Line of return of fuel
17/3 — the Line of supply of fuel
Y62 — the Injector

Location of the service valve (1/1) dumpings of pressure on the fuel highway of engines of series 112 and 113


1/1 — the Service valve 1/4 — the Screw 2/1 — a resonator Casing 17 — the Fuel highway	17/1 — Bolts 17/2 — the Line of supply of fuel Y62 — Injectors

PERFORMANCE ORDER

Before starting to work, familiarize with the precautionary measures given in the previous Section.

After performance described below procedure you only remove superfluous pressure from fuel system. In pipelines there will be a gasoline. Before disconnecting any fuel hose, accept all necessary precautionary measures.

The main components of fuel systems of petrol engines are the fuel tank located in it the fuel pump with the sensor of a stock of fuel, the fuel filter, injectors, a regulator of pressure and a set of connecting lines.
At the working engine fuel in a path of a power supply system is under pressure which continues to remain during even rather long time after ignition switching off. Before a detachment of any of system components pressure in a step should be dumped.
The simplest way of dumping of pressure in a power supply system is engine start at the taken safety lock of the fuel pump, - wait spontaneous останова the engine, then, for a guarantee of completeness of dumping of pressure, turn it several times a starter. If to start the engine it is not possible, turn it a starter within several seconds. Having finished procedure, switch off ignition and return into place removed safety lock.
At car repair shops pressure in a power supply system dump via the service valve located on the fuel distributive highway and working by a principle of a simple nipple. Wrap up the valve rags, remove a cap and press a nipple, - do not forget to return on termination of procedure a cap into place.
Remember that after a sbrasyvaniye fuel pressure/removal on start of the engine leaves a power supply system a little bigger, than usually, time, - it is necessary to turn within several seconds a cranked shaft a starter until pressure in system will be restored, and fuel will fill all gasoline pipe lines.