Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
- Current leaving and service
   Active system of the prevention of term of approach planned THAT (ASSYST)
   Schedule of routine maintenance
   General information on settings
   Check of levels of liquids, control of leaks
   Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
   Replacement of impellent oil and oil filter
   Check of brake system
   Power supply system check, replacement of the fuel filter
   Check of a condition and replacement of hoses of an impellent compartment, localization of leaks
   Check of a condition of multicostal belts of a drive of auxiliary units
   Check of functioning of system of cooling and frost resistance of cooling liquid, liquid replacement
   Check of a condition of system of production of the fulfilled gases
   Replacement and check of level of ATF, AT filter replacement
   Visual check of tightness of automatic transmission
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of boots of power shafts
   Check of central air of air
   Greasing of limiters of doors and cylinders of locks
   Visual control of a seat belt and safety cushion block
   Check of operability of headlights and horn
   Check of a condition and replacement of brushes of screen wipers
   Check of a condition of the battery, care of it and charging
   Replacement of the salonny filter
   Replacement of brake liquid
   Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Visual check of tightness of automatic transmission

 PERFORMANCE ORDER

In AT it is not required to change oil during all term of operation.

  1. The following belongs to number of the most probable places of development of leakages of ATF:

    · Plane of a joint of the block of cylinders and AT (a back epiploon of the crankshaft);
    · A place of connection of a power shaft to a transmission;
    · Drain stopper;
    · Jellied stopper.

  2. Clear AT case.
  3. Possible places of leaks sprinkle with a thin layer of chalk or talc.
  4. Make a trial trip on distance about 30 kilometers.
  5. Lift the car on the lift or over a viewing hole and by smudges of oil determine a place of leakage of oil.
  6. Eliminate leak and fill in oil in a transmission.