Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
- Systems of cooling, heating and air conditioner
   + System of cooling of the engine
   - Systems of ventilation, heating and air conditioning
      General information and security measures
      Removal and control panel installation by functioning of systems of heating/ventilation/air conditioning (for models 163.113/136/154/172/174 on 31.8.01)
      Removal and installation of the salonny filter
      Removal and installation of the fan of the heater/conditioner of air and its resistive assembly
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the step-by-step electromotor of a drive of a zaslonka of switching of modes of air circulation
      Removal and installation of the electromotor of a drive of a mixing zaslonka
      Removal and installation of a casing of the heat exchanger of the heater/evaporator of the conditioner of air
      Fast check of serviceability of functioning of central air of air
      Removal and installation of auxiliary ventilyatorny assembly, - models 163.136/154/157/172 of the corresponding complete set
      Removal and installation of the podsasyvayushchy fan of the sensor of temperature of salonny air, - models 163.113/136/154/157/172/174 with 1.9.99 on 31.8.01
      Removal and installation of the sensor of temperature of external air, - except models 163.128
      Removal and installation of the sensor of temperature of the evaporator
      Removal of a casing of the To/in evaporator
      Removal and To/in evaporator installation
      Removal and To/in condenser installation
      Removal and installation of the broad valve
      Removal and receiver dehumidifier installation
      Removal and installation of the module of management To/in (for models 163.113/136/154/172/174 on 31.8.01)
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Fast check of serviceability of functioning of central air of air

Fast check of serviceability of functioning of central air of air (on an example of the minibus of a series 901, - check is made for M-class models in a similar manner)

1 — a temperature Measuring instrument
2 — the Observation port of a receiver dehumidifier

3 — the Detector of leakages of a coolant


 PERFORMANCE ORDER

  1. The illustrative material on fast check of serviceability of functioning of central air of air is presented on an illustration which all references meeting in the text concern.
  2. Tire out the car in a shadow, open all windows.
  3. Transfer the handle of a choice of a temperature mode to the situation COLD (Cold).
  4. Include a mode of supply of fresh air.
  5. Completely open sections through passage snuffled all air lines.
  6. Start the engine on single turns.
  7. Include To/in, - turns of the engine should increase.
  8. Include the maximum high-speed mode of functioning of the fan.
  9. Through an observation port of a receiver dehumidifier (2) make sure of lack of signs of a puzyreniye of a coolant.

At primary start of svezhezapravlenny system formation of air bubbles should not cause concern, - wait about 10 minutes, - bubbles should disappear.

  1. Attentively study an external condition of all components refrigerator To/in, by means of the special detector check them on existence of signs of development of leaks.
  2. Transfer the fan to a high-speed mode "1" and by means of a special measuring instrument (1) measure temperature leaving via the central deflectors of the dashboard of air. 5 minutes of functioning of system later the temperature of air submitted to salon should be in range limits +2°С ÷ +12°С, and the To/in compressor should pass to a cyclic mode (in, otherwise it is necessary to check a condition of the sensor switch of temperature of the evaporator.
  3. Switch off the conditioner and muffle the engine, - more detailed checks of To/in system should be carried out in the conditions of a car-care center workshop.