Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   - Forward suspension bracket
      Removal and installation of assembly of the forward bridge
      Removal, check and installation of forward shock-absorbers
      Removal and installation of a torsionny bar
      Removal and installation of torsionny springs
      Removal and installation of the bottom cross-section lever, replacement of the forward axial plug
      Removal and installation of the top cross-section lever
      Check of a condition of spherical support of a rotary fist
   + Back suspension bracket
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment

Removal and installation of torsionny springs

Details of installation of torsionny springs of a forward suspension bracket

16а — Torsionnaya a spring
16b — the Squeezing level

16с — the Bolt
16f — the Bolt

Details of installation of torsionny springs of a forward suspension bracket

16а — Torsionnaya a spring
16b — the Squeezing level
16с — the Bolt
16d — the Persistent lever
16е — the Profile plug

16f — the Bolt
16g — the Face cover
16h — the Screw
16i — the Boot


 PERFORMANCE ORDER

  1. Details of installation of torsionny springs of a forward suspension bracket are shown on illustrations which all references meeting in the text concern.
  2. To Poddomkratta the car also establish it on props.
  3. By means of Columbus measure size of a pretightness of a spring (16а) - at installation the pretightness should be kept.
  4. Having turned out a bolt (16с), release a spring bar (16а).
  5. Release a bolt (16f) fixings of the profile plug (16е) and shift the last back on a bar.
  6. Take assembly of a torsionny spring from under the car.
  7. Weaken the screw (16h) and remove a face cover (16g).
  8. Liberate a torsionny bar (16а) from the persistent lever (16d).
  9. Installation is made upside-down, - previously grease a nakatanny site of a bar. Pay attention to the marking (shooter) regulating the provision of a bar (16а) of rather persistent lever (16d). Do not forget to grease a bolt (16с) and to fill the same greasing its boot (16i). Track observance of initial size of a pretightness of a spring.
  10. Check correctness of level of landing of the car and the direction of optical axes of headlights, in case of need make necessary adjustments.