Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   - Forward suspension bracket
      Removal and installation of assembly of the forward bridge
      Removal, check and installation of forward shock-absorbers
      Removal and installation of a torsionny bar
      Removal and installation of torsionny springs
      Removal and installation of the bottom cross-section lever, replacement of the forward axial plug
      Removal and installation of the top cross-section lever
      Check of a condition of spherical support of a rotary fist
   + Back suspension bracket
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment

Removal and installation of a torsionny bar

Details of installation of a torsionny bar of a forward suspension bracket

And — release Models till 31.07.98

In — release Models from 01.08.98


 PERFORMANCE ORDER

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

Remkomplekta of racks of a torsionny bar are issued only for release models from 01.08.98, - in case of failure of components of earlier versions it is necessary to make complete replacement of rack-mount knots by more modern!

  1. Details of installation of a torsionny bar are shown on an illustration which all references meeting in the text concern.
  2. Remove protection of a case.
  3. Remove a noise isolation.
  4. Remove collars (22b) from the bottom cross-section levers of a suspension bracket (4) and rubber plugs (22а).
  5. Release the bottom bracket (21b) fastenings of a rack and remove a torsionny bar (10).
  6. Remove from a bar rubber plugs (22а and 21а), previously having marked their adjusting provisions.
  7. On release models from 01.08.98 remove washers (21i).
  8. Remove fixing collars (21k).
  9. In case of need release a fixing nut, take an axial bolt and remove a rack of a torsionny bar (21е).
  10. Vypressuyte from a rack the plug (21h).
  11. Installation is made upside-down, - track correctness of an arrangement of rubber plugs, before a tightening of fixture center a bar.