Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of assembly of the back bridge
Removal, dismantling and installation of back racks
Removal and installation of a torsionny bar
Removal and installation of the bottom cross-section lever
Removal and installation of the top cross-section lever
Remove also installation of a longitudinal extension
+ Steering
+ suspension bracket Geometry
+ Body
+ Onboard electric equipment
|
Removal and installation of the top cross-section lever
Details of installation of the top cross-section lever of a back suspension bracket
|
|
|
|
In total самоконтрящиеся bolts and nuts are subject to replacement without fail! |
- Details of installation of the bottom cross-section lever of a back suspension bracket are shown on an illustration which all references meeting in the text concern.
- Remove back wheels, remove запаску (except models with fastening of the last on the holder behind a door of a back and models 163.174). At the corresponding complete set remove the external holder of a spare wheel.
- On models 163.174 (ML 55 AMG) remove loker of protection of wheel arches.
- Remove the wheel sensor (L6/3, - in case of the left lever).
- Disconnect rack-mount assembly (6j) from a lateral beam of a suspension bracket (see. Section Removal, dismantling and installation of back racks).
- Squeeze out the top spherical support (91а) of stupichny assembly.
- Disconnect from a stretcher the bottom cross-section lever (see. Section Removal, dismantling and installation of back racks).
- Give fixing nuts, previously having marked adjusting provisions (shooters), take axial bolts (91b) and separate the top lever (91) from a frame beam.
- Check a condition of rubber axial plugs and a spherical support, in case of need make replacement (see. Sections Removal and installation of the bottom cross-section lever, replacement of the forward axial plug and Check of a condition of spherical support of a rotary fist).
- Installation is made upside-down, - at installation of levers assembly of the bridge should occupy strictly horizontal situation. Track correctness of combination of the landing labels (arrow) put in the course of dismantle.
|
|
|
|