Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of assembly of the back bridge
      Removal, dismantling and installation of back racks
      Removal and installation of a torsionny bar
      Removal and installation of the bottom cross-section lever
      Removal and installation of the top cross-section lever
      Remove also installation of a longitudinal extension
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment

Remove also installation of a longitudinal extension

Details of installation of a longitudinal extension of a back suspension bracket


 PERFORMANCE ORDER

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

  1. Details of installation of a longitudinal extension of a back suspension bracket are shown on an illustration which all references meeting in the text concern.
  2. Remove back wheels.
  3. On the models equipped with xenon headlights disconnect from the right extension (97) draft of a regulator of level of landing (120а).
  4. on models 163.174 (ML 55 AMG) lift an additional fuel tank over a back stretcher.
  5. Having used a stripper, liberate the sharovy hinge of an extension from stupichny assembly.
  6. Previously having marked adjusting situation kulachkovy a bolt concerning a stretcher, disconnect an extension (97) from the last. Estimate a condition of the spherical hinge (see. The section Check of a condition of spherical support of a rotary fist), in case of need make its replacement.
  7. Installation is made upside-down, - track, that at a fixture tightening the bridge occupied strictly horizontal situation. Track correctness of combination of the labels put in the course of dismantle.