Mercedes M-Class W163

since 1997 of release

Repair and car operation

Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of assembly of the back bridge
      Removal, dismantling and installation of back racks
      Removal and installation of a torsionny bar
      Removal and installation of the bottom cross-section lever
      Removal and installation of the top cross-section lever
      Remove also installation of a longitudinal extension
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment

Removal and installation of the bottom cross-section lever

Details of installation of the bottom cross-section lever of a back suspension bracket

6j — Rack-mount assembly
7а — the Bottom spherical support
94 — Nizhny the cross-section lever
125а — the Bearing with a nut
125b — the Bearing
125 — the Remote plug

125d — the Bearing
125е — the Bearing
125f — the Bolt
And — Version 1
In — Version 2

PERFORMANCE ORDER

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

Details of installation of the bottom cross-section lever of a back suspension bracket are shown on an illustration which all references meeting in the text concern.

Remove back wheels.

Disconnect rack-mount assembly (6j) from the bottom cross-section lever (94).

Remove the bearing with a nut (125а) and take from the lever (94) a bolt (125f).

Give fixing nuts, take axial bolts, separate the lever (94) from a stretcher and develop it down on a spherical support (7а).

In case of need holding a spherical head by means of TORX key, liberate a support (7а) from the lever (94).

Remove the bottom are cross-section the lever (94).

Estimate a condition of a spherical support (7а) (see. The section Check of a condition of spherical support of a rotary fist), in case of need remove a support (use an ex-tractor) and make its replacement.

Installation is made upside-down, - track, that when landing the lever and a bearing tightening with a nut (125а) assembly of the back bridge settled down strictly horizontally.