Mercedes M-Class W163

since 1997 of release

Repair and car operation

Removal and installation of the lever of switching of RKPP 716.644

Details of installation of the lever of gear shifting of RKPP 716.644 (ML 270 of CDI)

1 — the Basis of lever assembly 2 — the Coupling 3 — the Protective cover 4 — the Boot 5 — the switching Lever 6 — Fixing pins 7 — Carter RKPP 8 — a switching Rod 9 — the Transfer case	10 — the Contact socket of electroconducting 11 — Nuts 12 — the Cross-section beam with a back support of a suspension bracket of the power unit 13 — the Back driveshaft 14 — Bolts 15 — the Bolt 16 — Nuts 17 — Boltovaya a plate

PERFORMANCE ORDER

Details of installation of the lever of switching of RKPP 716.644 are shown on an illustration which all references meeting in the text concern. Include neutral transfer. Remove the handle and a cover of the lever of switching. Remove a protective cover (3) - try not to bend lock uvulas excessively. Turn out a bolt (15). Release clamps and remove a boot (4) - try not to bend lock uvulas excessively. Give nuts (16) and remove a boltovy plate (17). Turn out bolts (14), disconnect from a transfer case (9) back driveshaft (13), take him aside and tie up to a car frame, without allowing creation of excessive loads of the kardanny hinge and assembly of the central bearing (see. Head Suspension bracket and steering). Disconnect electroconducting (10) from the executive electromotor. Prop up transmission (7) and give nuts (11). Slightly приопустите transmission assembly, - try not to damage lines of communication. Having unblocked, take a fixing pin (6) and disconnect from transmission (7) lever assembly (1). Having pulled down, remove assembly (1). Installation is made upside-down, - track, that at connection to the lever (5) of a rod of switching (8) directing on the lever was on the party of a blokirator of inclusion of a reverse gear in the basis of lever assembly (1) (shooter). In summary check serviceability of functioning of the mechanism of switching.