Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + ignition and engine management Systems
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      General information
      The storage battery - the general information, recommendations about service
      Charge system - general information and security measures
      Check of system of a charge
      Removal and generator installation
      Removal and installation of a driving pulley of the generator
      Removal and installation of a regulator of tension
      System of start of the engine - the general information and precautionary measures
      Removal and starter installation
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a driving pulley of the generator

At generator replacement with run more than 100 000 km it is necessary to replace also and its driving pulley.

Petrol models

Details of installation of a driving pulley of the generator on petrol models

1 — Flantsovannaya a nut
2 — a generator Shaft

3 — Mnogoruchyeva a pulley

Details of installation of a driving pulley of the generator on petrol models

4 — the Bilateral six-sided face head


 PERFORMANCE ORDER

  1. To detail of installation of a driving pulley of the generator on petrol models it is shown on illustrations which all references meeting in the text concern.
  2. Remove the generator (see. Section Removal and generator installation).
  3. Block a generator (2) shaft from a provorachivaniye by a screw-driver prodevaniye in a bilateral six-sided head (4), release a flantsovanny nut (1).
  4. Remove mnogoruchyevy a driving pulley (3).
  5. Installation is made upside-down.

Diesel models

Details of installation of a driving pulley of the generator on diesel models

1 — Mnogoruchyeva a pulley
2 — a generator Shaft

3 — the Face head
4 — the Protective cap


 PERFORMANCE ORDER

  1. To detail of installation of a driving pulley of the generator on petrol models it is shown on an illustration which all references meeting in the text concern.
  2. Remove the generator (see. Section Removal and generator installation).
  3. Remove a protective cap (4).
  4. By means of a face head (3) release a fixing nut and remove a driving pulley of the generator (1), - blocking of a shaft (2) is made by means of the section of a face head equipped with a notch (3).
  5. Installation is made upside-down.