Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
+ Coupling
- Driveshafts
Removal and installation of the forward driveshaft
Removal and installation of the back driveshaft
Removal and installation of the intermediate bearing of a back cranked shaft
+ Power shafts
+ Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the back driveshaft
Details of installation of the two-section back driveshaft
|
|
|
|
Самоконтрящиеся bolts and adjusting washers are subject to replacement without fail! |
- Details of installation of the two-section back driveshaft are shown on an illustration which all references meeting in the text concern.
- Turn out самоконтрящиеся bolts (1b) fastenings of forward section (1) back driveshaft to a target flange of a transfer case, remove adjusting washers (1с).
- Turn out самоконтрящиеся bolts (2а) fastenings of back section (2) of the driveshaft to a leading flange of back differential.
- Turn out screws (7d) fastenings of the intermediate bearing of assembly of the driveshaft to a frame beam.
- Accurately omit shaft assembly, submit it back and take from under the car.
- Estimate degree of wear of the hinge of equal angular speeds (CV JOINT) on the forward end of a shaft, kardanny hinges and the intermediate bearing, in case of need replace a shaft assembled.
- In case of need remove the intermediate bearing (see. Section Removal and installation of the intermediate bearing of a back cranked shaft).
- Installation is made upside-down, - carefully smooth out interface surfaces, try not to allow deformations of bearing assembly.
|
|
|
|