Mercedes M-Class W163

since 1997 of release

Repair and car operation


Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   - Ignition and engine management systems
      Main data and security measures
      Checks of a control system by ignition and injection
      Search of malfunctions - the general information and preliminary checks
      Check and adjustment of a corner of an advancing of ignition
      Spark plugs
      Removal and installation of coils of ignition, - petrol models
      Removal and installation of the sensor of provision of a cranked shaft (CKP)
      Removal and installation of the sensor of provision of a camshaft (CMP), - the series 111 engine
      Removal and installation of the sensor of the Hall of a camshaft, - petrol engines of series 112, 113 and diesel engines of a series 612
      Removal and installation of sensors of a detonation (KS), - petrol engines
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   + charge and start Systems
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Техніка обгону

Removal and installation of the sensor of provision of a camshaft (CMP), - the series 111 engine

Details of installation of the CMP sensor of the engine of a series 111

11/1 — the Sealing ring
11/2 — Adjusting laying

L5/1 — the CMP Sensor

CMP sensor adjustment with the help щупа lezviyny type


 PERFORMANCE ORDER

  1. Details of installation of coils of ignition of the diesel engine of a series 612 are shown on an illustration, - do not forget to replace a sealing ring (11/1).
  2. After replacement of the CMP sensor (L5/1) it is necessary to make installation of a gap of a camshaft: turn a cranked shaft so that the segment of an asterisk of a camshaft appeared opposite to the sensor and with the help щупа lezviyny type measure a gap between a segment of an asterisk and the sensor, - demanded value makes 0.5 mm, in case of need make the corresponding adjustment by selection of adjusting laying (11/2): 0.1 ÷ 1.0 mm.