Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
- Mercedes-Benz cars of a class M (W163)
   Identification numbers of the car
   Acquisition of spare parts
   Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   Diagnostics of malfunctions
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Engine start from the auxiliary power supply

Use of the auxiliary power supply will help to make engine start in an extreme situation, however then it is necessary to find out and eliminate the reason of a discharge of the battery. Number of the most typical reasons treat:

  1. Carrying out numerous unsuccessful attempts of start of the engine, or leaving of lighting devices included for a long time at the muffled engine;
  2. Violation of serviceability of functioning of system of a charge (weakened or the driving belt of the generator is torn off, connecting electroconducting is damaged, or the generator is faulty actually);
  3. Malfunction of actually storage battery (electrolit level fell, or there was an accumulator service life).
At performance of start of the engine from the external power supply it is necessary to pay attention to observance of some special precautionary measures:
  1. It is not necessary to try to start the engine from the frozen storage battery, - previously it warm up;
  2. On models with the petrol engine engine start from the auxiliary power supply should be made only at the cold power unit and the catalytic converter;
  3. It is not necessary to carry out start by means of the device for the accelerated charging of the storage battery;
  4. Before connecting the auxiliary battery, make sure that ignition is switched off;
  5. Use only cables of sufficient cross-section section with the isolated terminal clips;
  6. Track, that all consumers of the electric power (lighting and heating devices, screen wipers, etc.) also were switched off;
  7. Put on protective gloves and points;
  8. Make sure that the auxiliary battery on the target tension corresponds established on your car;
  9. If as the auxiliary power supply the battery established on other vehicle is used, track, that cars did not adjoin AT ALL with each other;
  10. The car engine from which battery start is made, should work at single turns;
  11. Make sure that transmission is included on neutral transfer (RKPP), or transferred to the situation "R" (AT);
  12. From the discharged battery remove ventilating covers and cover openings with rags.

Connect the end of a red wire from a special set to the positive plug of the sat-down battery. The second end of a red wire connect to the positive plug of the auxiliary battery.

Connection of wires should be made in the order specified illustrations (pay attention that the negative wire from the auxiliary power supply is connected not to the plug of the sat-down battery, and mass of the power unit of the emergency car)

And — the Discharged battery
In — the Battery from which start is made
X — Mass of the power unit of the emergency car

The storage battery is located in a special niche in the right part of a luggage compartment of the car.

Connect a black wire to the negative plug of the auxiliary battery, its second end connect to reliably earthed point on the block of the started engine (a bolt or an arm), whenever possible far away from the battery.

Make sure that connecting wires do not adjoin to moving components in impellent compartments of both cars (a krylchatka of the fan, driving belts, etc.).

Execute standard procedure of start of the engine. Leave the engine working at single turns. For the purpose of prevention of throws of tension at the moment of a detachment of electroconducting include a heater of back glass and the heater fan, then disconnect wires, operating as it should be, the return to an order of their connection (see above). On termination of procedure switch off superfluous consumers of the electric power.