Mercedes M-Class W163

since 1997 of release

Repair and car operation



Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
- Transmission line
   - Coupling
      Assessment of degree of wear of a conducted disk of coupling
      Removal, installation and coupling check
      Removal and installation of the main cylinder
      Removal and installation of the executive cylinder of coupling
      Air removal from a hydraulic path of a drive of coupling
   + Driveshafts
   + Power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal, installation and coupling check

Details of installation of components of assembly of coupling


 PERFORMANCE ORDER

  1. The illustrative material on procedures of removal/installation of components of coupling is given in an illustration which all references meeting in the text concern.
  2. Remove RKPP (see. Head Manual box of gear shifting).
  3. In stages, no more than on 1 ÷ 1.5 turn for an approach, turn out fixing bolts (9) (Allen) and remove assembly of a basket of coupling (6) and a conducted disk (5), - when using an aligning opravka (012) act strictly according to instructions of manufacturers of the adaptation.
  4. Estimate a condition of conducted and press disks.
  5. Estimate a flywheel condition.
  6. Defective components replace.
  7. On the models equipped with RKPP of a series 717.4 remove vyzhimny the bearing (7) and the bifurcate lever of switching off of coupling (8). Estimate degree of wear of components, in case of need make replacement.
  8. On the models equipped with RKPP of a series 716.6 check the central operator on existence of signs of wear and development of leaks. In case of need make replacement.
  9. Installation is made upside-down, - track correctness of installation of a conducted disk, on models from RKPP of a series 717.4 grease deepenings in the bifurcate lever of switching off of coupling under a spherical bolt of a case of a box and a rod of a pusher of the executive cylinder (arrow).