Removal and installation of assembly of podrulevy switches
Details of installation of assembly of podrulevy switches
Details of installation of assembly of podrulevy switches
|
|
- Details of installation of podrulevy switches are shown on illustrations which all references meeting in the text concern.
- Disconnect a negative wire from the battery.
- Remove a steering wheel and a spiral contact drum of the horn/module of a driver's face-to-face safety cushion (see. Head Suspension bracket and steering).
- Turn out fixing screws (1) and remove the bottom section (2) casings of a steering column.
- Remove the top section (3) casings of a column.
- Remove lateral finishing panels (12), - at the corresponding complete set disunite contact sockets of electroconducting on panels.
- Turn out screws (4) and disunite the socket (9).
- Turn out the screw (8) and remove the switch of management of functioning темпостата (S40).
- Turn out screws (5) and liberate assembly of the combined podrulevy switches (S4) from clamps (6) and remove it from a shaft of a steering column (7).
- Installation is made upside-down.
|
|
|