Mercedes W163
+ Mercedes-Benz Cars of a class M (W163)
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Avtomaticheckaya transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
+ Forward suspension bracket
+ Back suspension bracket
+ Steering
- Suspension bracket geometry
Check of geometrical parameters of the unit of bridges
Check and adjustment of height of road gleams
Corners of installation of wheels of the car - the general information
Check and adjustment of disorder and выбега
Check and convergence adjustment
Check of size of a divergence of forward wheels in turn
+ Body
+ Onboard electric equipment
|
Check and adjustment of height of road gleams
Check and adjustment of height of road gleams of axes
|
|
Check and adjustment of height of road gleams of axes |
|
|
Check and adjustment of height of road gleams of axes, - the left back point of measurement |
|
|
Check and adjustment of height of road gleams of axes, - the left forward point of measurement |
Check and adjustment of height of road gleams of axes
|
|
- The corresponding illustrative material is presented on illustrations which all references meeting in the text concern.
- Estimate degree of wear of protectors, replace defective tires.
- Check correctness of pressure of a rating of tires, in case of need make the corresponding adjustment.
- The height of a road gleam of axes of the car is determined by a tilt angle of the bottom levers of the corresponding suspension bracket.
- Plant a magnetic measuring element (086b) in deepening in the bottom lever of a suspension bracket (4).
|
|
On the models equipped with xenon headlights turn out a bolt (4а) so that he ceased to act from the lever (4). The plate of a measuring element (086b) should settle down a flute at an angle 90 ° to the movement direction. |
- Write down results of measurements for each lever of both suspension brackets.
- Adjustment of height of a road gleam of a forward axis is made by correction of landing of support of torsionny springs.
- Correction of a gleam of a back axis is carried out by means of replacement of screw springs of rack-mount assemblies.
|
|
|
|